How to make super sweet Harvest Hello boxes

Today I have a super sweet Harvest Hello box that you can easily make and I am going to show you how! First, have you seen the cute Harvest Hello bundle?

Harvest Hellos Bundle (En)
$35.00

The box below was created using the Come to Gather paper too - for added visual interest:

Come To Gather Designer Series Paper
$11.50

 

You can use this bundle for amazing cards, on scrapbook pages and even to make boxes like this one!

You can add a face to the pumpkins or not. Without a face these boxes have an apple image:

 

 

Here's how to make these super sweet Harvest Hello boxes:

Harvest Hello mint boxes

Supplies: 

Stamp Sets – Harvest Hellos (150581)

Card Stock (CS) – Pretty Peacock (150880); Cajun Craze (119684); Mint Macaron (138337)

Ink Pads – Pretty Peacock (150083); Memento Tuxedo Black* (132708)

Misc. – Come To Gather Designer Series Paper (DSP) (150454); Basic Black Stampin’ Write Marker* (100082); Apple Builder Punch (150663); Multipurpose Liquid Glue (110755); Bone Folder (102300); Paper Snips (103579)

 

*The black ink pad and marker are optional - use if you are adding the jack-o-lantern face. 

 

Measurements:  

• Pretty Peacock CS: 3” x 3” scored ¾” from all four sides; ½” x 6-3/4” 
• scraps of DSP and Pretty Peacock, Cajun Craze, and Mint Macaron CS for punching

 

Instructions:

1. Burnish all score lines using a Bone Folder.
2. Cut one score line at each corner of the 3” x 3” CS.
3. Fold up the sides and glue each tab onto the inside of the adjacent side, to form the box.
4. Run a Bone Folder along the ½” strip of CS to soften it, then glue the ends onto the inside of the box sides.
5. Stamp the pumpkin twice in Pretty Peacock ink onto a piece of the DSP. If desired, stamp the face in Memento black ink, and fill in the face using a Black marker.
6. Stamp the stem twice in Pretty Peacock ink onto a scrap of Cajun Craze CS.
7. Stamp the leaf twice in Pretty Peacock ink onto a scrap of Mint Macaron CS.
8. Punch out all the stamped pieces.
9. Punch two pumpkins from a scrap of Pretty Peacock CS.
10. Glue the stem and leaf onto the back of each DSP pumpkin.
11. Glue the Pretty Peacock CS pumpkin onto the back of the DSP pumpkins.
12. Glue the pumpkins onto the sides of the box.